INSTALLATION AND ELECTRICAL CONNECTION 1- 2-Following the pictures assamble water heater using accessories and extra parts supplied with advice. On no account do not use other accessories. 3-In the case of device is fed by a tank, it should have minimum hight of 250 cm. above water outlet. 4-Connect elektricity to the appliance from the nearest wall outlet using cable with 3 x 2,5 mm2 cross section area. 5-Before connection of cable cut off electricity, switching off fuse. 6-To provide safe assembly of connection use junction box at the end of the cable. Open cover let end of the cable in the junction box, after pass it through the rubber gasket coupling and tighten up the nut. 7-Connect ends of the cable appropriately to L= phase, N= neutral and * provide grounding. After make sure that you made the connection correctly. Close the cover. 8-After connection is completed, insert the fuse back. 9-Resistance of fuse must be 25 Ampers. If no, replace. 10-The device must be grounded. 11-Get it connected by a qualified ELECTRICIAN.